本文詳細介紹了基于嵌入式系統的網絡變頻器設計過程。本文整體上是分三部分來介紹:1.SVPWM 變頻器的硬件設計與實現。利用智能功率模塊PM20CSJ060 構成系統主電路中的逆變電路，以ARM 單片機LPC2292 為系統控制電路的控制核心；2.以太網接口的硬件開發。利用網卡芯片RTL8019AS 完成以太網硬件接口電路;3.變頻器的軟件開發。完成了基于μC/OS-II 的系統整體軟件的開發。
關鍵字: 變頻器；嵌入式；以太網；
Abstract: The article introduces in detail the process of designing the hardware and software of the network inverter based on embedded system. This paper introduces the process of design in the following three parts: 1. The design and realization of the hardware of SVPWM inverter. IPM PM20CSJ060 is used to form chopping circuit of main circuit, ARM single chip computer LPC2292 is regarded as control center of the system control circuit. 2. The development of hardware of Ethernet interface. 3. The development of software of inverter. The development of the whole system software based on μC/OS-II is completed.
Keywords: Inverter; Embedded; Ethernet